Hydro Jetting in Mississauga

Signs you need it

Not every blockage calls for the jetter. It earns its place when ordinary cabling has stopped producing lasting results.

• The same drain has been snaked two or three times within a year
• A camera shows heavy grease or scale coating the pipe walls
• Fine tree roots have entered at a joint but the pipe itself is sound
• Sand or silt has settled in a floor drain or building trap
• A commercial-style kitchen at home sees heavy daily use

How we do the work

1. Look first. We normally run a camera before jetting. Pressurized water is unsuitable for pipe that is cracked, collapsed or badly offset.
2. Choose the nozzle. Rear-facing jets pull the hose forward while scouring; a rotating head is used for scale and stubborn grease.
3. Work from the cleanout. We enter through an accessible cleanout so debris flushes downstream toward the city sewer, not back into the house.
4. Make several passes. The hose is advanced and retracted in sections until the water runs clear.
5. Confirm the result. A second camera pass shows you the pipe after cleaning, and we note its condition in writing.

Mississauga homes and this job

Older neighbourhoods south of the QEW, including Lorne Park and Mineola, have mature trees whose roots seek out sewer joints. Clay and early concrete laterals in these areas benefit from periodic jetting once roots are cut. Elsewhere, homes on the clay soils common across Peel can see silt drawn into weeping tile and floor drains. When a pipe is found to be broken rather than merely dirty, jetting stops and the conversation turns to sewer line repair.

After jetting

A freshly cleaned line stays clear longest when its users help. Keep grease out of kitchen drains, avoid flushing wipes even if they are labelled flushable, and watch for slow drainage returning. If roots were present, ask us about a follow-up camera check in a year to judge regrowth.

What affects the cost

• Line length from the access point to the city connection
• Whether a usable cleanout exists or one must be installed
• The amount of root mass or scale to remove
• Camera inspection before and after, which we recommend on every job

Because the scope depends on what the camera reveals, we describe the options and their trade-offs before any water goes into the line. Clean drains also support basement flood prevention, since a partially blocked lateral is one route by which sewage backs up during heavy rain. For lighter, single-fixture clogs, standard drain cleaning is usually the more sensible choice.

On site, in order

On every job

• Drop cloths down before any tool comes out
• Water or fuel shut and tagged while we work
• Every joint we made checked dry before we pack up
• Old parts shown to you, then hauled away

Answers our Mississauga crew gives most